Rmp60 Specification - Renishaw RMP60 Installation Manual

RMP60 installation guide

RMP60 specification

Principal application
Dimensions
2.10 Weight (without shank)
Transmission type
Radio frequency
Switch-on methods
Switch-off methods
Spindle speed (maximum)
Operating range
Receiver/interface
Sense directions
Unidirectional repeatability
Stylus trigger force
Factory setting:
XY low force
XY high force
+Z
Maximum setting:
XY low force
XY high force
+Z
Minimum setting:
XY low force
XY high force
+Z
Stylus overtravel
1 Performance specification is tested at a standard test velocity of 480 mm/min (18.9 in/min) with a 50 mm stylus
Significantly higher velocity is possible depending on application requirements.
2 Trigger force, which is critical in some applications, is the force exerted on the component by the stylus when the
probe triggers. The maximum force applied will occur after the trigger point (for example overtravel). The force value
depends on related variables including measuring speed, machine deceleration and system latency.
3 Tests carried out using a 50 mm stylus.
Workpiece inspection and job set-up on multi-tasking machines,
machining centres and gantry machining centres.
Length
Diameter
With batteries
Without batteries
Frequency hopping spread spectrum (FHSS) radio
2400 MHz to 2483.5 MHz
Radio M-code, spin on or shank switch
Radio M-code, timer, spin off or shank switch
1000 r/min
Up to 15 m (49.2 ft)
RMI-Q or RMI-QE combined interface and receiver unit
±X, ±Y, +Z
1.00 µm (40 µin) 2s
2 3
0.75 N, 76 gf (2.70 ozf)
1.40 N, 143 gf (5.04 ozf)
5.30 N, 540 gf (19.06 ozf)
2.00 N, 204 gf (7.19 ozf)
3.50 N, 357 gf (12.59 ozf)
14.00 N, 1428 gf (50.36 ozf)
0.50 N, 51 gf (1.80 ozf)
0.90 N, 92 gf (3.24 ozf)
3.50 N, 357 gf (12.59 ozf)
XY plane
+Z plane
76 mm (2.99 in)
63 mm (2.48 in)
876 g (30.90 oz)
826 g (29.14 oz)
1
±18°
11 mm (0.43 in)