RMP60 installation guide
2.
4.16
3.
4.
5.
Battery good
Radio on
(omitted if "multiple probe mode" was selected) or
Battery status
Battery low
or
Switch-on method
Shank on
Release the stylus.
Deflect the stylus for 20 seconds until the
status LEDs start to flash yellow eight times.
Whilst the status LEDs are flashing
yellow to confirm that a master
reset is required, release the stylus
and then hold the stylus deflected
again until the eight yellow flash
sequence has ended.
System status LED
Previous settings have been cleared.
The probe now has default settings.
Spin on
or