Canon imageCLASS MF7470 Basic Operation Manual page 350

Printer Settings
1. IMAGE REFINEMENT
2. DENSITY
3. TONER SAVER
6. PAGE LAYOUT
1. BINDING
2. MARGIN
Sets whether to print smoothly the jagged outlines of
characters and graphics.
– ON
– OFF
The results of image refinement may be different depending on the
types of characters and graphics you want to print.
Adjusts the print density. (1‑9)
Sets whether the toner saving mode is enabled.
– OFF
– ON
If [ON] is selected for Toner Saver, very light or finely detailed
images may not be printed clearly.
Sets the printing layout.
Sets the binding position for two‑sided printing.
– LONG EDGE
– SHORT EDGE
– You cannot create a binding margin with this setting alone. Use
this setting in combination with the Margin setting to create a
binding margin.
– For two‑sided printing, the orientation of the image on the back
side of the page may be changed by this setting.
Sets the page margin in inches or millimeters.
– INCHES (‑01.90INCHES–01.90INCHES)
– mm (‑50.0 mm–50.0 mm)
– If this setting moves the image outside the printable area, part of
the image may be cut off.
– Pressing [▶] increases the setting value by 0.01" (0.5 mm) each
time the key is pressed. Pressing [◀] decreases the value by 0.01"
(0.5 mm) each time. Holding down either [◀] or [▶] continuously
speeds up the value alteration.
12‑21