Canon imageCLASS MF7470 Basic Operation Manual page 316

Message
LTR Load paper.
No response.
(imageCLASS MF7480/
MF7470 Only)
No response from the server.
Check the settings.
(imageCLASS MF7480/
MF7470 Only)
Out of resources. Wait for
a moment, then perform
operation again.
(imageCLASS MF7480/
MF7470 Only)
Description
The optimum paper size
selected by the Automatic
Paper Selection mode is not
available in the machine.
– The server was not running
when you tried to send.
– The network connection
was lost when you tried to
send. (Either you could not
connect to the destination
or the connection was
lost before the job could
complete.)
– A TCP/IP error occurred
when you tried to send an
e‑mail or I‑fax.
The specified server settings
are incorrect, or the server is
not turned ON. Alternatively,
the machine's TCP/IP resources
may be low.
You cannot browse the
network due to a lack of TCP/IP
resources. This may be because
documents have just been
continuously sent or are being
continuously sent through FTP
or Windows (SMB).
Action
– Load the indicated paper
size into the machine. If you
press (Start) while this
message is displayed, prints
are made with the currently
selected paper size.
– When the message
continues to be displayed
even if the indicated paper
size is loaded, set Drawer
Eligibility For APS/ADS in
Common Settings (from the
Additional Functions screen)
for that paper drawer to
[On]. (See "Automatic Paper
Selection/Automatic Drawer
Switching," on p. 2‑25.)
– Check the destination.
– Check the status of the
network.
– Check that the network
cables and connectors are
properly connected.
Wait for a while, and try
browsing again. If you still fail,
try selecting another server.
Wait for a while, and try
browsing again.
11‑19