Canon imageCLASS MF7470 Basic Operation Manual page 317

Message
Place the original on the
platen glass.
Platen Glass is dirty.
Remove the original from the
feeder.
Remove the paper from the
output tray.
Replace the toner.
Return page 1 to the top, and
then press the Start key.
Set the IP Address.
(imageCLASS MF7480/
MF7470 Only)
There are too many
subdirectories.
11‑20
Description
The specified mode requires
that the original be placed on
the platen glass, but there is no
original on the platen glass.
The feeder's scanning area is
dirty.
The machine cannot scan your
original using the feeder. An
original is placed in the feeder
and on the platen glass.
Prints from the previous job
remain in the output tray.
Printing is not possible because
the toner has run out.
Scanning was stopped due to a
problem with the feeder.
This machine is not set with an
IP address.
You have exceeded the
maximum number of
subdirectory levels allowed.
Action
Place the original on the platen
glass.
Clean the feeder's scanning
area. (See "Manual Feeder
Cleaning," on p. 10‑7.)
Remove the original from the
feeder.
Remove the prints remaining
in the output tray. Printing
automatically resumes.
Replace the cartridge. (See
"Replacing the Cartridge," on
p. 10‑14.)
Arrange the originals in page
order with the first page on
top. Place the originals back
into the feeder's original supply
tray, and press (Start).
Specify the IP Address Settings
in TCP/IP Settings in Network
Settings in System Settings
(from the Additional Functions
screen), then turn the
machine's main power off and
back on again. (See Chapter
6, "Network (imageCLASS
MF7480/MF7470 Only)," in the
Reference Guide, or "Set the
Machine for Network Usage
(imageCLASS MF7480/MF7470
Only)," in the Starter Guide.)
The directory level that you
are trying to access cannot be
specified. Specify a different
destination.