Piper ARCHER III Pilot Operating Handbook page 295

PA-28-181, ARCHER ill
•
SECTION 7 · DESCRIPTION AND OPERATION (continued)
Legend • Figure I (continued)
6. Timer Mode AnnunciaLion
(FLT) mode is annunciated here.
7. Frequency Selector Knobs - Selects the standby frequency when FRQ is
displayed and directly selects the active f
timer functions is selected. The frequency selector knobs may be rotated
either clockwise or counlcrclockwise. The small knob is pulled out lo tune
the 1 ·s. The small knob is pushed in
the I00's with rollover inlo the IOO0's. These knobs arc also used to set
the desired time when the elapsed timer is used in the countdown mode.
8. Off/Volume Control (OFF/VOL) - Controls primary power and audio
output level. Clockwise rotation from OFF position applies primary power
to receiver; further clockwise rotation increases audio level. Audio mul­
ing causes the audio oulpul to be muted unless the receiver is locked on a
•
valid station.
9. Set/Reset Bullon (SET/RST)
the elapsed timer whether it is being displayed or
I 0. Flight Time/Elapsed Time Mode Selector Button (FLT/ET) - The Flight
Timer/Elapsed Time mode selector buuon. when pressed, alternatively
selects eiLhcr Flight Timer mode or Elapsed Timer mode.
I I. Frequency Transfer Button (,FRQ) - The FRQ transfer bullon, when
pressed. exchanges the active and standby frequencies. The new frequen­
cy becomes active and the former active frequency goes into standby.
12. BFO Button - The BFO button selects the BFO mode when in the
depressed position (see Note under item 3 ).
13. ADF Button - The ADF butt.on selects either the ANT mode or the ADF
mode. The ANT mode is selected with the ADF button in the out position.
The ADF mode is selected with the ADF bulton in the depressed position.
14. Bearing Pointer (on PFD) - The cyan arrow indicates magnetic bearing to
the station in degrees .
•
ISSUED: December 22, 2017
REVISED: May 7, 2018
- EiLher Lhe elapsed time (ET) or flight time
r
equency whenever either of the
rune the I O's. The outer knob tum: : :;
10
- The set/reset bullon, when pressed.
SECTION 9
SUPPLEMENT 2
resets
1101.
REPORT: VB-2749
9 of 10 9-17