European Atex Hazardous Area Compliance - ADS TRITON+ Installation, Operation And Maintenance Manual

Note: This is an excerpt from an agency-controlled
document for illustration purposes only. Changes to the
base controlled document require agency approval. For a
full-size copy of this drawing, please contact ADS and
request drawing number 8000BK0009-CERT.
Note: The Telog Ru-33 and Ru-35 can be connected to
the COMM + EXT PWR port on the TRITON+ monitor
using the Telog-Triton Comm Cable (ADS p/n 8000-0054-
01). However, this configuration has not been included on
this drawing because the Telog unit is not certified for IS
operation. Therefore, an installation involving this
configuration will not be considered intrinsically safe,
unless the Ru-33 or Ru-35 is installed outside the
hazardous area.
Cellular Modem Information and Compliance
Wireless telemetry is provided via a third-party, FCC- and carrier-
approved, commercial HSPA+/GSM, Verizon LTE-M, or
WorldWide LTE_M modem inside the TRITON+ monitor and a
corresponding antenna. Two antenna options are available through
ADS. However, customers may obtain their own antennas to
accommodate specific needs or requirements. If a customer-
supplied antenna is preferable or required, consult an ADS
representative prior to installing the antenna to ensure it will
adequately support TRITON+ monitor communications and
compliance.

European ATEX Hazardous Area Compliance

The following instructions apply to equipment covered by the
certificate numbered Sira 09ATEX2027X (TRITON+, USB Serial
Interface, Combo Sensors CSX Series, IS PSTN modem, and IS
modem DAA). Reference European ATEX Directive 2014/34/EU,
Annex II, 1.0.6:
Introduction 1-13