Triton+ System Certification - ADS TRITON+ Installation, Operation And Maintenance Manual

The TRITON+ flow monitor has been CSA (Canadian Standards
Association) certified to CLASS 2258 03 – Process Control
Equipment, Intrinsically Safe and Non-Incendive Systems – For
Zone 0 Hazardous Locations, Ex ia IIB T3 (152°C) areas in
Canada; and CSA certified to CLASS 2258 83 – Process Control
Equipment, Intrinsically Safe and Non-Incendive Systems – For
Class I Zone 0 Hazardous Locations, AEx ia IIB T3 (152°C) areas
in the USA (equivalent to Class I, Division 1, Groups C & D).
It is the customer's responsibility to ensure that the certification(s)
provided for the ADS equipment meets applicable regulatory
requirements.
Note: TRITON+ models include the 8000-FST-IM-
4WW, 8000-FST-IM-4VZ, 8000-FST-IM-EP-4VZ, 8000-
FST-IM-GL, and 8000-FST-IM-EP-GL.

TRITON+ System Certification

The TRITON+ unit and associated telemetry equipment are
certified for use only with approved ADS battery packs, sensors,
communication cables, and telemetry equipment. Connection of
any non-approved devices could result in unsafe operation and will
immediately void the warranty and IS certification.
Note: Connecting the Telog Ru-33 or Ru-35 or the
Ayyeka Wavelet 4R to the ADS TRITON+ is an approved
application and, therefore, will not void the TRITON+
warranty. However, because the Telog and Ayyeka units
are not IS certified, the installation will not be considered
intrinsically safe if an Ru-33, Ru35 or Wavelet monitor is
installed in the manhole with the monitor.
Introduction 1-3