Maintenance Restrictions - ADS TRITON+ Installation, Operation And Maintenance Manual

Maintenance Restrictions

As mentioned earlier, all ADS TRITON+ flow monitors are
manufactured to meet IS standards. The monitor's IS certification
can be voided instantly if proper maintenance and service
procedures are not followed. ADS must restrict certain
maintenance tasks to ADS IS-certified technicians.
ADS-certified technicians carefully inspect and document their
repairs of IS monitors. This inspection and documentation process
provides legal protection should the monitor's performance or
safety be in question.
If you experience trouble with this equipment, please refer to this
manual for troubleshooting guidelines. The following maintenance
procedures may be performed in the field, but they must be
performed as described in this manual:
Installing and swapping monitor
Installing and swapping sensors
Installing and swapping battery pack
Swapping fuses in power regulator in monitor
Installing and swapping SIM card on monitor port
Replacing pressure depth sensor dryer tube and desiccant beads
Installing and swapping ExPAC (applicable only when not
housed within an XBUS or XIO), XBUS, or XIO
Cleaning sensors
Confirming sensors
Note: Please note that, in all applications, only ADS IS-
certified Service Technicians are authorized to perform
component-level service on the TRITON+.
If you have any questions about the procedures, warranty
information, or level of service you are allowed to perform on a
monitor, please contact ADS through the contact information listed
at the end of this chapter.
Introduction 1-9