Table of Contents
Advertisement
Hardware Preparation and Installation
Hardware Preparation and Installation
2.8.2
Removing an SFP Module
Procedure
In order to remove an SFP module, proceed as follows.
1. Remove any connected cable from the SFP module.
2. Open the SFP latch. Note that the latch mechanism of your SFP module may be slightly
different compared to the latch shown in the following figure.
48
ATCA-F125 (6873M Artwork) Installation and Use (6806800J94P)
Advertisement
Table of Contents
Need help?
Do you have a question about the ATCA-F125 and is the answer not in the manual?