Refit & Check Window - Valor MADRONA MF28JN Installation Manual

Installation
Refi t and Check Window
1. Place the window on the firebox frame and hold it in
place while fastening its bolts, pushing and turning
them 90 degrees. Ensure the pin at the end of the
bolt is through the window fixing tabs.
x 4
2. Pull out and release the top and bottom of the win-
dow to ensure the springs return it.
3. Apply firm hand pressure on the window frame
to ensure the window is sealed tight against the
firebox.
4. If the Hot Glass Warning plate has been removed
from the front lower corner of the window, re-
install it by sliding it between the glass and the
frame as indicated.
Hot Glass Warning Plate
Refit & Check Window
WARNING
The window unit must be correctly
installed, fastened and sealed after
servicing or serious bodily injury and/or
damage to the appliance may result.
To ensure a safe operation:
• Double-check that the window frame is
correctly installed;
• Verify that the spring-loaded bolts are
hooked properly to the window tabs then;
• Pull out and release the top and bottom
of the window to ensure the springs
return it;
• Ensure the window is sealed before
operation.
WARNING
Failure to install the window correctly can:
• Leak carbon monoxide;
• Affect the performance of the fireplace;
• Damage components;
• Cause overheating resulting in dangerous
conditions.
Damages caused by incorrect window
installation is not covered by the Valor
warranty.
27