Reinstall And Check Window - Valor 1400MN Owner's Manual

Cleaning your fireplace

Reinstall and check window

To reinstall the window, you'll need the window latch
pull handle, located on the bottom of the fireplace.
1. Rotate the four side spring latches to the vertical
position. Holding the window at the top and bot-
tom, place the top edge on top of the fi rebox.
Lift the window slightly so the side tabs slide back
over the corresponding roller bushings at the fi re-
box sides. Hold
the window back
and fl at against
the fi rebox.
2. Using the latch pull handle, hook the four spring
latches over the corresponding tabs as shown.
16
WARNING
The window must be correctly installed,
fastened and sealed after servicing or
serious bodily injury and/or damage to
the appliance may result.
To ensure a safe operation:
• Double-check that the window is
correctly installed;
• Verify that the four spring-loaded latches
are hooked properly to the four window
tabs then;
• Pull out the top of the window, then the
Roller
bottom and release to ensure the springs
bushing
return it;
• Ensure the window is sealed by pressing
firmly around it before operation.
WARNING
Failure to install the window correctly
can:
• Leak carbon monoxide.
• Affect the performance of the fireplace.
• Damage components.
• Cause overheating resulting in
dangerous conditions.
Damage caused by incorrect window
installation is not covered by the Valor
Warranty.
Removable panel
Window latch
pull handle