Battery Holder - Valor MADRONA MF28JN Installation Manual

Installation
Install Battery Holder
The batteries that power the receiver and handset need
to be installed prior to pairing and use.
1. Take the receiver out from under the firebox.
2. Insert four 1.5 V new high quality alkaline batter-
ies in the battery holder and one new high quality
alkaline 9 V battery in the remote handset.
The battery holder and cable are supplied with the
appliance.
3. Connect the cable to the receiver as shown.
4. Connect the other end of the cable to the battery
holder..
28
5. Place the receiver and battery holder as shown un-
der the firebox, to the left of the control valve
(placement may vary with installed options).

Battery holder

6. Use a heat-resistant tie to gather any extra cable
between the receiver and the holder.
Caution
DO NOT let the cable of the battery holder
touch the burner plate above, it will melt during
operation.
Caution
Do not put batteries in the receiver as leaking acid
could damage its circuit board.
Battery Holder