Preparation; Before Installing - Valor MADRONA MF28JN Installation Manual

Preparation

Attention
ONLY qualified licensed or trained personnel
should install this appliance.
1. BEFORE YOUR START, YOU NEED TO KNOW FROM
THE HOMEOWNER:
• Required accessories to install with stove: fuel
bed, fan, venting accessories;
• Hearth, if used;
• Venting confi guration.
2. Unpack the appliance however keep it on its packag-
ing base to avoid damaging the components under-
neath. Removing all items packed inside and around
it. Recycle packaging.
3. Check that you have everything required for the in-
stallation, using the Pack Content sheet. Also, check
that you have:
• Fuel bed (packed separately);
• Stove casing with barrier screen (in multiple
cartons);
• Venting accessories;
• Gas conversion kit, if necessary;
• Fan, if necessary;
• Electrical accessories, if fan is used.
4. Carefully read the Installer's Checklist included
with the appliance for the installation sequence.
Read also this manual and the stove casing
manual to have all information necessary for the
installation.
Installation Considerations
Fan (Blower)
Allow for and install electrical wiring if there will be a
fan (blower) to install. Ask the homeowner if you are
not sure.
Venting Configuration
This unit is supplied with a top vent take-off and is field
convertible to a rear vent take-off. Plan routing of vent
taking into consideration stove and vent clearances,
allowable vent terminal locations BEFORE cutting a hole
in the roof or wall. Avoid penetrating the wall/roof at
structural members.
Gas Line Routing
Consider visibility of shuf-off or step-down regulators,
etc. when planning gas line routing.
Upack Appliance
The Madrona appliance is supplied separately from the
stove casings. The Traditional stove—MFCS01 (black) or
MFCS02 (majolica brown)—and the Modern stove
MFCS05 are each supplied in multiple cartons. You
must have in hand the stove casing before starting the
assembly of the appliance.
Unpack the cartons carefully. We strongly recommend
that you leave the appliance sitting on the packaging
base in which it came to avoid damaging the control
valve, wires and pipes already attached until it is
ready to install in the stove casing.
Some parts are packed in the cardboard sleeve around
the appliance; make sure you take them all out of the
packaging. Make sure you have all the components
including the stove casing components before you start
the installation
Caution
LEAVE THE APPLIANCE ON ITS PACKAGING BASE
to avoid damage to the control valve, wires and
pipes until ready to install into stove casing.

Before Installing

17