Table of Contents
Advertisement
Installation
Refi t and Check Window
1. Insert the window inside the appliance case and rest
it on the fi rebox front bottom tabs.
2. While holding it, push in and screw the bottom two
spring-loaded bolts to secure them.
3. Insert the top two spring-loaded bolts pins into
the slot/holes and turn them 90 degrees to secure
them.
4. Hook the window baffl e to the top of the window
frame. Be careful not to hook it onto the fi rebox
frame—see images below.
This side covers the top front
of the window frame above the
glass & hides the bolts
Window Baffl e
(appliance shown without its front frame for clarity)
5. Grab the top of the window and baffl e and pull
them forward and release to check that the window
opens slightly and returns confi rming the good
function of the spring-loaded mechanism.
6. Similarly, check the bottom of the window by pulling
it forward and releasing it.
90°
This side goes on top
of the window frame
and is hooked to it
fi rebox frame
window
frame
window
baffl e
Refit & Check Window
WARNING
The window unit must be correctly
installed, fastened and sealed after
servicing or serious bodily injury and/or
damage to the appliance may result.
To ensure a safe operation:
• Double-check that the window frame is
correctly installed;
• Verify that the spring-loaded bolts are
hooked properly to the window tabs then;
• Pull out the top of the window and release
it to make sure the springs return it;
repeat with the bottom of the window;
• Ensure the window is sealed before
operation.
WARNING
Failure to install the window correctly can:
• Leak carbon monoxide;
• Affect the performance of the fireplace;
• Damage components;
• Cause overheating resulting in dangerous
conditions.
Damages caused by incorrect window
installation is not covered by the Valor
warranty.
window frame
window baffl e
Appliance front view
cut out heat baffl e
(for clarity)
appliance top frame
window baffl e
35
Advertisement
Table of Contents
