Refit & Check Window - Valor HORIZON 534JN Installation Manual

Installation
Refi t and Check Window
1. Place window over the fi rebox.
2. While holding it, push in and screw the bottom two
bolts to secure them.
3. Insert the top two bolts pins into the slot/holes and
turn them 90 degrees to secure them.
4. Pull the top of the window forward and release to
check that it opens slightly and returns confi rming
the good function of the spring-loaded mechanism.
5. Similarly, check the bottom of the window by pulling
it forward and releasing it.
6. Apply fi rm pressure around the window frame to
ensure the window is sealed tight against the fi re-
box.
7. If the Hot Glass Warning plate has been removed
from the front lower corner of the window, re-
install it by sliding it between the glass and the
frame as indicated.
Safety warning plate
Refit & Check Window
WARNING
The window unit must be correctly
installed, fastened and sealed after
servicing or serious bodily injury and/or
damage to the appliance may result.
To ensure a safe operation:
• Double-check that the window frame is
correctly installed;
• Verify that the bolts and spring-loaded
bolts are hooked properly to the window
tabs then;
• Pull out the top of the window and release
it to make sure the springs return it;
repeat with the bottom of the window;
• Ensure the window is sealed before
operation.
WARNING
Failure to install the window correctly can:
• Leak carbon monoxide;
• Affect the performance of the fireplace;
• Damage components;
• Cause overheating resulting in dangerous
conditions.
Damages caused by incorrect window
installation is not covered by the Valor
warranty.
35