Table of Contents
Advertisement
3
G etting started
2 B
Getting started with the coolMONSTER/PM is very easy. For location of the connectors, see Appendix E:
Connector Layout. Take the following steps:
Turn off the power supply.
®
Connect the power supply to the coolMONSTER's power supply connector or power
®
the board through a backplane.
Plug a memory module into the memory socket of the coolMONSTER/PM.
®
Connect the CRT monitor to the CRT interface or a LCD panel to the JILI interface by
®
using a corresponding adapter cable.
Plug the keyboard and the mouse to the PS/2 connectors or use USB keyboard or
®
mouse.
Connect the floppy drive cable to the coolMONSTER's floppy interface. Attach the
®
floppy drive to the connector at the opposite end of the cable.
Connect the power supply to the floppy's power connector.
®
Plug a hard-drive data cable to the coolMONSTER's hard-disk interface.
®
Attach the hard disk to the connector at the opposite end of the cable.
®
If necessary, connect the power supply to the hard disk's power connector.
®
If required, plug a ISA or PCI extension card to the appropriate slot in the backplane
®
Make sure all your connections have been made correctly.
®
Turn on power.
®
Enter the BIOS by pressing the F2 key during boot-up. Make all changes in the BIOS
®
setup. See the BIOS chapter of this manual for details.
Kontron User's Guide
coolMonster/PM
9
3 2BGetting started
Advertisement
Table of Contents
