Table of Contents
Advertisement
Chapter 3
3.
Getting Started
The easiest way to get the MOPSlcdLX board running is to use a starter kit from Kontron Embedded Modules
GmbH. Take the following steps:
‚
Connect the power supply to the starter kit baseboard (part of the starter kit).
ƒ
Plug a suitable DDR-SDRAM memory module into the RAM socket of the MOPSlcdLX.
„
Plug the MOPSlcdLX to the PC/104 bus connector on the starter kit baseboard.
…
Make all necessary connections from the MOPSlcdLX to the starter kit board. (cables come with
the starter kit). The starter kit board offers various interfaces on standard connectors.
†
Connect the CRT monitor to the CRT interface or a LCD panel to the JILI interface by using the
corresponding adapter cable.
‡
Plug a keyboard to the starter kit's keyboard connector.
ˆ
Connect the floppy drive (part of the starter kit) with the data cable (part of the starter kit) to
the MOPSlcdLX floppy interface and connect the power supply to the floppy's power connector.
‰
Plug a hard-drive data cable to the MOPSlcdLX hard-disk interface. Attach the hard disk to the
connector at the opposite end of the cable. If necessary, connect the power supply to the hard
disk's power connector.
Š
Make sure all your connections have been made correctly. Turn on the power.
‹
Enter the BIOS by pressing the Del key during boot-up. Make all changes in the BIOS Setup.
See the BIOS chapter of this manual for details.
Kontron User's Guide MOPSlcdLX
5
Getting Started
Advertisement
Table of Contents
