Getting Started - Kontron MOPS/386A User Manual

GETTING STARTED

3.
The easiest way to get the MOPS/386A board running is to use a starter kit from Kontron
Embedded Modules GmbH. Take the following steps:
1. Turn off the power supply (part of the starter kit).
2. Connect the power supply to the starter kit baseboard (part of the starter kit).
3. Plug a graphics-controller board to the PC/104 bus or the ISA bus slots on the
starter kit. (There are starter kits available with and without PC/104 graphics
boards included.)
4. Connect the CRT monitor to the graphics controller board.
5. Plug the MOPS/386A to the PC/104 bus stack on the starter kit baseboard.
6. Make all necessary connections from the MOPS/386A to the starter kit board.
(Cables come with the starter kit). The starter kit board offers various interfaces on
standard connectors.
7. Plug a keyboard to the starter kit's keyboard connector.
8. Connect the floppy drive (part of the starter kit) with the data cable (part of the
starter kit) to the MOPS/386A floppy interface.
9. Connect the power supply to the floppy's power connector.
10. Plug a hard-drive data cable to the MOPS/386A hard-disk interface. Attach the
hard disk to the connector at the opposite end of the cable.
11. If necessary, connect the power supply to the hard disk's power connector.
12. Make sure all your connections have been done correctly.
13. Turn on the power.
14. Enter the BIOS by pressing the F2 key during bootup. Make all necessary changes in
the BIOS setup. See the BIOS chapter of this manual for details.
Getting Started 6
Kontron
MOPS/386A User's Guide