Table of Contents
Advertisement
11
E thernet INTERFACE
1 0 B
The coolMONSTER/PM comes with one Ethernet interface, which uses the ICH4's integrated 32-bit PCI
LAN controller in combination with the Intel® 82562 platform LAN connect device. The network
controller supports a 10/100Base-T interface. The device auto-negotiates the use of a 10Mbit/sec or
100Mbit/sec connection.
All major network-operating systems and several real-time and embedded operating systems support the
interface.
11.1
E thernet Controller
5 4 B
The Intel® 82562 features are:
IEEE 802.3 10Base-T/100Base-TX compliant physical layer interface
®
IEEE 802.3u Auto-Negotiation support
®
IEEE 802.3x Full Duplex Flow Control standard
®
Digital Adaptive Equalization control
®
Link status interrupt capability
®
10Base-T auto-polarity correction
®
Platform LAN connect interface support
®
Diagnostic loopback mode
®
1:1 transmit transformer ratio support
®
Low power (less than 300mW in active transmit mode)
®
Reduced power in "unplugged mode"
®
Note:
The Ethernet interface works according to the common criteria of the embedded technology market segment.
11.2
C onnector
5 5 B
The 10/100Base-T interface is available on a standard 8-pin RJ45 jack. It is available at the slot panel of
the coolMONSTER/PM through Connector X7.
To find the location of the Ethernet interface, please see the Appendix E: Connector Layout chapter.
The following table shows the pin-out of the Ethernet connector.
Header
Kontron User's Guide
coolMonster/PM
Pin
Signal Name
1
TXD+
2
TXD-
3
RXD+
4
NC **
5
NC **
6
RXD-
7
NC **
8
NC **
Function
100/10BASE-T Transmit
100/10BASE-T Transmit
100/10BASE-T Receive
For internal use only
For internal use only
100/10BASE-T Receive
For internal use only
For internal use only
26
11 10BEthernet INTERFACE
In/Out
Differential Output
Differential Output
Differential Input
Differential Input
Advertisement
Table of Contents
