E Ide Interfaces; C Onnector; C Onfiguration; S Ignal Descriptions - Kontron coolMonster/PM User Manual

Hide thumbs Also See for coolMonster/PM:
Table of Contents

Advertisement

15

E IDE Interfaces

1 4 B
PCI-bus devices serve as primary and secondary IDE hosts on the coolMONSTER/PM. The controller
supports:
Up to Ultra DMA 100 mode
®
Up to PIO mode 4 timing
®
Multiword DMA mode 1 and 2 with independent timing
®
The controller also supports IDE legacy and IDE native mode configuration. The coolMONSTER/PM
features two IDE interfaces that can drive four hard-disk drives. When two IDE devices share a single
adapter, they are connected in a master/slave, daisy-chain configuration. If only one drive is in the
system, you must set it as the master.
15.1

C onnector

7 3 B
IDE interface 1 is available through Connector X4 (39 pins). This interface is designed in 0.1" grid for
optimal connectivity to a 3.5" hard drive. IDE interface 2 is available through Connector X6 (44 pins.) It
is designed in a 2mm grid for optimal connectivity to a 2.5" hard drive.
There are several accessories available for IDE interface 2 connectivity.
You can use two cables to directly connect a hard disk in a 2.5" form factor (KAB-IDE-2MM, Part Number
96021-0000-00-0) or a 3.5" form factor (KAB-IDE-25, Part Number 96020-0000-00-0).
15.2

C onfiguration

7 4 B
The EIDE interfaces offer several configuration settings. Refer to the Main Menu and I/O Device
Configuration Submenu and the Master or Slave Submenu in the Appendix B: BIOS Operation chapter for
additional information on configuration.
15.3

S ignal Descriptions

7 5 B
H DRSTJ (Reset)
2 2 1 B
The reset signal is active low during power up and inactive thereafter.
®
D ASP_P, DASP_S (Primary, secondary master/slave select)
2 2 2 B
This signal drives a LED whenever a connected hard disk is being accessed or when a
®
second drive is present. This signal is active low when the hard disk is busy.
15.4
C onfiguration
7 6 B
The EIDE interfaces offer several configuration settings. Refer to the Main Menu and I/O Device
Configuration Submenu and the Master or Slave Submenu in the Appendix B: BIOS Operation chapter for
additional information on configuration.
Kontron User's Guide
coolMonster/PM
36
15 14BEIDE Interfaces

Advertisement

Table of Contents
loading

Table of Contents