Table of Contents
Advertisement
4
Multimeter Setup Options
Enabling smooth mode
Smooth is used to smoothen the refresh rate of the readings in order to reduce the impact
of unexpected noise and to help you achieve a stable reading. You can permanently enable
or disable Smooth from the Setup menu. The smooth refresh rate can be set from 0001 to
9999. The smooth time is defined as the set value +1. Smooth will be restarted when the
variation count is exceeded, when the range is changed, or after a multimeter function or
feature is enabled. The variation count is set to the value used for the AutoHold feature
("Changing the variation count" on page 121).
Parameter
tiME
To enable Smooth:
1 Press
2 Press
Figure 4-2
3 Press
change the last digit shown from
4 Press
step 3 to edit.
5 Press
6 Press and hold
122
Range
(0001.d to 9999.d) or (0001.E to 9999.E)
while turning the rotary switch to access the Setup menu.
Shift
Esc
or
on
until
Hold
icon appears to the left of the primary display.
tiME display - Smooth
Vsense
or
to set the Smooth refresh rate. To permanently enable Smooth,
or
on
to navigate to the consecutive values, then repeat
Hold
to save your changes, or press
Hz
Save
until the multimeter restarts to return to normal operation.
Shift
Esc
Defaul t setting
0009.d (disabled)
is shown on the secondary display and the
(disabled) to
(enabled).
to discard your changes.
Shift
Esc
Keysight U1281A/U1282A User's Guide
Advertisement
Table of Contents
