Table of Contents
Advertisement
2. The results obtained for the flagged (positive) tests
will be displayed. Touch the cycle key next to the test
name to change the displayed result to the next option
of the available reported results. Once the cycle key
is touched, the result for that test will be printed and
stored with an exclamation point (!), even if the result
is reset to its original value. If the selected output for-
mat is "CCS" (see Section 3, Step I-1b), the "!" will
be transmitted with the results. Touch
ing is complete for that record to return to the Con-
firmatory Report.
3. Repeat Steps 1 and 2 above for each desired record.
When all editing is complete, touch
Confirmatory Report. Once you leave the Edit routine,
you will not be able to edit the run any further.
4. If there are records in the Microscopic Report, they
will be displayed next. After both the Confirmatory and
Microscopic Report screens have been exited, results
for the records included in the Confirmatory Report
are sent to the printer and/or computer (all other
records are printed/ transmitted as soon as they are
available).
Recalling Results
Up to 500 patient records and 200 control records are
stored in memory. If you want to recall one or more
records, proceed as follows:
1. Touch Menu to display the Option Menu, then touch
Memory.
2. You can choose to recall all patient records, all con-
trol records, or the last batch of patient records. The
number of records in memory is shown next to the
first two options. Touch the desired option.
Revised 5/01
3. The first (earliest) record of the selected group will be
displayed. The date and time the record was stored is
shown, along with the technician ID (if available), SEQ
#, and ID for the record. All results are then listed;
positive results (as defined through the Setup Routine)
are flagged with an asterisk (*) and edited results with
an exclamation (!).
4. Locate the first record you want to review using the
when edit-
movement keys shown on the display. The next lower-
or higher-numbered record in memory is recalled
when the
lower or higher is recalled when the
to exit the
are used.
5. Printing records from memory: If you want to print
one or more records, touch
several printing options:
5.
a. Print only this result: The record that was dis-
played when the
printed. The SEQ # and ID of that record will con-
tinue to be displayed on the print option menu.
5.
b. Print a group of results: You can specify the begin-
ning and ending records to be printed; all records
in the sequential group will be printed. Use the
movement keys to display the first record (lowest
SEQ #) you want to have printed, then touch
to change the selection to the last record to be
printed. This record must have a SEQ # that is
higher than or the same as the first record. Touch
to begin printing.
5.
c. Print all patient (control) results: All records that
were recalled can be printed when this option is
selected.
5.
After printing is complete, the screen returns to the
first (earliest) record of the group selected in Step 2
previously. (If "Print a group of results" was select-
ed, the display first returns to the screen from which
the group was selected. Touch
to the first record.)
and
keys are used; the record 10
and
; you will be given
key was touched can be
as needed to return
keys
4.9
Advertisement
Table of Contents
Troubleshooting
