Table of Contents
Advertisement
6. To review, change, or delete a loadlisted number or
color/clarity description that has already been entered,
use the
and
keys to display the desired num-
ber, using the loadlist order number to help you locate
the proper location:
6.
NOTE: The ID number cannot be changed or deleted
during the Run mode; changes must be made through
this screen while the instrument is in the Ready mode.
6.
a. Change the ID number using the
the cursor to the left as needed, then enter the cor-
rect number.
6.
b. Delete the number from the loadlist by touching
; you will be given the option to delete only the
ID number being displayed or all IDs in memory.
Touch the desired option.
6.
c. Edit the color and/or clarity description as
described in Step 3 above.
6.
d. Touch or scan
to accept the new number and
color/clarity descriptions.
7. When all IDs have been entered into the loadlist, you
can print the list by touching
return to the Ready/Run screen to begin testing spec-
imens. (The ID list can also be printed by touching
Menu from the Ready/Run screen, then touching Print
and selecting ID list.)
7.
NOTE: Once testing is started, no additional IDs can
be added to the loadlist, nor can an ID number be
changed or deleted until the run is completed or can-
celled. If the run is cancelled, the remaining IDs in the
loadlist can be edited, but no new IDs can be added
until the run is complete.
8. Test each specimen in the same manner as described
in Step A previously ("Basic Operation"). The
Ready/Run screen will show each ID number and the
color/clarity descriptions in the same order as they
were entered into the loadlist. For each specimen:
Revised 5/01
8.
8.
9. When the strip for the last loadlisted specimen has
key to move
C. If IDs are Used Without a Loadlist
to testing each specimen, as follows:
1. Touch the ID key to enter the number for the first spec-
2. Enter or scan the ID number for the specimen about
. Then touch
to
2.
2.
2. •
2.
3. The display will change to allow entry of the next ID
3.
a. Check that the ID number and color/clarity descrip-
tions are correct for the specimen about to be test-
ed. Edit the color and clarity, if necessary, as
described in Step A-1.
b. Dip and place a Reagent Strip as described in Steps
A-2 and A-3.
been moved to the read area, you will not be allowed
to place any additional strips on the table. The push
bar will stay at the right side and the display will
change to "
Completing Run. Please Wait.
Specimen IDs can also be entered immediately prior
imen. The ID entry screen is displayed (see Step B-1
above).
to be tested; if needed, enter or scan the color and
clarity descriptions (see Steps B-2 and B-3 for com-
plete directions). When this information has been cor-
rectly entered, touch
(or scan the
the color/clarity card).
NOTE: There is no need to scan the
you are scanning barcoded ID numbers AND if:
• neither color nor clarity is being used
or
• clarity is not being used and color is being deter-
mined by the Analyzer.
number, and the push bar will move to the left so a
strip can be placed on the loading station. Dip and
place a Reagent Strip, as instructed in Steps A-2 and
A-3.
NOTE: If another ID is entered without a strip being
detected, the instrument automatically creates a load-
list (see Step B previously).
"
code from
bar code if
4.7
Advertisement
Table of Contents
Troubleshooting
