Figure 2-9
8.
c. Set the paper into position behind the printer. Then,
place the front tabs of the cover into their slots and
feed the end of the paper through the opening in
the cover. Snap the cover into place.
9. If not already installed, place a liner into the waste bin
(Figure 2-10).
Figure 2-10
Revised 5/01
Interfacing to a Printer
The CLINITEK 500 can be interfaced to most 80-
column, continuous feed printers or to the CLINITEK
Form Printer via the printer (parallel) port that is found
on the rear of the instrument.
1. Some printers may include an interface cable that is
appropriate for use; if not, you will need to obtain the
cable separately. Refer to Appendix CPI, "COMPUT-
ER AND PRINTER INTERFACE," for the pin specifica-
tions for the male connector. The other end of the
cable will be dependent upon the particular printer.
Appropriate cables are available at most retail com-
puter stores.
2. Connect the appropriate end of the interface cable to
the printer port on the CLINITEK 500 (labeled "
(see ‹!£ Figure 2-11 for location); connect the other
end to the printer.
‹!£
‹#£
Figure 2-11
®
")
‹@£
2.5