Bayer HealthCare CLINITEK 500 Operating Manual page 31

2. If Protein has been selected as a reported test, the
first screen shows three different options for Protein,
one for each of the different groups of Bayer Reagent
Strips that can be used on the instrument. The report-
ed results for protein vary slightly, depending upon
which group of Reagent Strips is used (see the Tables
of Results in Section 1). The first option is for the tra-
ditional Bayer Reagent Strips (e.g., MULTISTIX 10 SG);
the second is for MULTISTIX PRO 6B and MULTISTIX
PRO 6K strips (not available in all countries); and the
third is for all other MULTISTIX PRO strips. By select-
ing the first positive level for each group, you can
then select a different strip for use in testing (Step C-1
previously) without having to change the selection of
the first positive level of the protein test.
2. NOTE: Nitrite is not listed, since it has only one posi-
tive level. Also, the P:C ratio is not listed, since these
results already include a description of "NORMAL" or
"ABNORMAL."
2. a. Touch the cycle key for the test you want to change,
repeating until the desired level is displayed.
2. b. When all tests on the first screen are correct, touch
to display the remaining tests (if additional tests
are reported).
2. c. When all tests are correctly set, touch
ed to return to the previous option menu.
4. Normal levels for SG/pH:
3. The lower and upper limits of the range considered to
be normal for SG and pH can be selected by touching
this key. Each limit is set separately; however, the upper
limit must be higher than or equal to the lower limit.
+
–
3. a. Touch the or keys next to the limit you want
to change to raise or lower the displayed number.
With each touch, the number will change by one
reporting level until it is equal to the opposite limit
or is at the highest or lowest reporting level.
Revised 5/01
3. b. When all limits have been set, touch
to the previous option menu.
3. NOTE: This option can be selected only if "Mark pos-
itives" (Step E-2 previously) is ON.
5. Normal levels for CRE:
3. As with SG and pH, the lower and upper limits of the
normal range for creatinine can be selected by touch-
ing this key. However, you must be using a MULTISTIX
PRO Reagent Strip in order for this option to be active.
Each limit is set separately, but the upper limit must
be equal to or higher than the lower limit.
3. a. Touch the
to change to raise or lower the displayed number.
With each touch, the number will change by one
reporting level until it is equal to the opposite limit
or is at the highest or lowest reporting level.
3. b. When both limits have been set, touch
to the previous option menu.
3. NOTE: This option can be selected only if "Mark pos-
itives" (Step E-2 previously) is ON.
F. Setup Menu #5
When all options on the fourth menu have been cor-
rectly set, touch
as need-
for example:
Set options.
Color-
determined by Analyzer
Color choices
Clarity choices
Use default COL/CLA
during run-ON
+
–
or keys next to the limit you want
to proceed to the next Setup menu;
to return
to return
3.9