Table of Contents
Advertisement
Remove the used Reagent
6
Strip and discard it in the
proper container.
Wipe the test strip table
with a damp, lint-free tissue.
Do this as often as needed to
prevent urine from building up.
Also, wipe the table after testing
a urine that is visibly bloody or
that gives a very high result on
any test pad.
Getting Results
If results are printed:
The test results are automatically
printed. Press the PRINT key to
reprint the last set of test results.
Press PAPER, if desired, to add
blank lines after the results.
If results are displayed:
To view results, press the
repeatedly. When all results have
been displayed and recorded,
press EXIT. To display the
results again, press DISPL.
16
Summary of Steps:
Dip a new Reagent Strip
1
into the urine sample.
Press
2
removed from the urine; at the
same time, drag the strip edge
against the side of the container.
Blot by touching the edge
3
of the strip to a paper towel.
Place it on the test strip
4
table within 10 seconds.
Discard the strip when the
5
test is finished.
Thermal print will fade
with time. Also, do not cover
thermally printed results with
transparent tape.
key
as the strip is
Hide quick links:
Advertisement
Table of Contents
