Table of Contents
Advertisement
Chapter 11 Diagonal Measurements
Setting Up for the Measurement
Setting Up for the Measurement
Guide: This information relates to flowchart item 4 in Figure 11-1.
Previous experience in setting up and making non-diagonal linear
measurements can help you learn to set up and make diagonal
measurements.
If you have not already done so, perform the following setup procedures
before using the rest of the instructions in this chapter to make a diagonal
measurement. Refer to the Agilent 5530 Getting Started Guide for
complete instructions when installing and starting the system for the first
time.
1
Mount the laser head on the tripod and place the tripod near the target
machine.
2
Connect the E1735A USB Axis Module and the E1736A USB Sensor Hub
to the USB connectors on your PC. Connect the laser head and remote
control unit to the axis module. Connect the sensors to the sensor hub.
3
Plug in and turn on all equipment.
Before you set up for diagonal measurements:
a. Determine:
•
the type of machine you are working on, and
•
which body diagonals or face diagonals will be measured
(Figure 11-4)
Examples of machine types are:
•
stacked-stage with vertical spindle—table moves in X and Y
•
single-slide table—column moves in Y and Z, table moves in X
only
11-10
Measurements Reference Guide
Advertisement
Table of Contents
