Quick Reference Guide - Directechs FORD12 Installation Manual

Quick Reference Guide

Sending commands to your vehicle
Whether you want to remote start the engine, lock/unlock the doors or pop the trunk,
there are 3 possible ways you can send commands to your vehicle, using the:
• Factory remote.
• Aftermarket remote.
• Directed SmartStart application via your smartphone.
If applicable, you can also start the engine remotely by pressing the Lock button 3
times quickly on your factory remote.
Vehicle takeover with Get In and Go
Close the vehicle doors, hood and trunk, then press
1
the Remote Start button on the transmitter to start the
vehicle.*
Press the Unlock button on the factory or aftermarket
2
remote.*
Complete the following steps within 45 seconds or the vehicle will shut down.
Enter the vehicle, while making sure the factory
3
remote is inside with you.
Depress the brake pedal, put the car in gear and
4
drive off.
* Icon and remote appearance may differ depending on the model purchased.
Get In and Go
Get In and Go is designed to provide users with easy takeover when entering their
Push-to-Start (PTS) equipped vehicle, once it has been remote started.
Typically, users would have to remote start their vehicle, then get inside and press
the PTS button to perform a takeover. There is therefore a physical action required
to drive away. With Get In and Go, you simply remote start the vehicle, unlock the
doors, get in and go... All that's left to do is put the gear in drive and drive off.
Pit stop/idle mode
The vehicle pit stop/idle mode feature is not available in this firmware.
List of available commands
Note that the information below is for many Viper, Clifford, Python, Avital and
Automate models. Icons and commands may differ depending on the model and
options purchased. Refer to your authorized installation center for more specific
information.
Button(s)
Press Remote
Start button*
Press Unlock on
either remote*
* Icon and remote appearance may differ depending on the model purchased.
14:36
Enter vehicle
with remote
Ready to
drive off
Actions
Press & hold for 1 second to lock.
Press & hold for 1 second to unlock.
14:36
Press & hold for 1 second to remote start.
*
* Press & hold for 5 seconds to activate the trunk release (optional).
14:36
Directed Digital Solutions FORD12
© 2021-02-04 Directed. All rights reserved.