Soft Reset; Hard Reset - Directechs FORD12 Installation Manual

Soft reset

A module reset will only erase the steps performed in "" on page <OV>. The firmware and settings flashed to the module will not
be affected.
If required for your installation, connect all the harnesses to the Directed Digital Solutions,
1
EXCEPT the 12-pin main power harness. Press and hold the programming button, then
connect the 12-pin harness to the module.
Wait 3 seconds until the LED turns ON solid orange then release the programming button.
2
The LED turns ON solid red.

Hard reset

Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings may need to
be reconfigured. Connect your module to a computer and use the web configuration tool to edit its programmable features.
If required for your installation, connect all the harnesses to the Directed Digital Solutions,
1
EXCEPT the 12-pin main power harness. Press and hold the programming button, then
connect the 12-pin harness to the module.
After 3 seconds the LED turns ON solid orange. Keep holding the programming button until
2
the LED flashes red, then orange slowly.
3
Release the programming button. The LED turns ON solid red.
55
Connect all but the
12-pin harness
& &
Solid Release Solid
Connect all but the
12-pin harness
& &
Solid Hold Flashes
&
Release Solid
Directed Digital Solutions FORD12
© 2021-02-04 Directed. All rights reserved.