Table of Contents
Advertisement
RIGOL
Tip
The probe compensation signal can only be used for probe compensation
adjustment and cannot be used for calibration.
Probe Compensation
When the probes are used for the first time, you should compensate the probes to
make them match the input channels of the oscilloscope. Non-compensated or
poorly compensated probes may cause measurement inaccuracy or errors. The
probe compensation procedures are as follows:
1.
Perform Step 1, 2, 3 and 4 specified in "Function Inspection".
2.
Check the displayed waveforms and compare them with Figure 1-12.
Over compensated
3.
Use a nonmetallic screwdriver to adjust the low-frequency compensation
adjustment hole on the probe until the waveform is displayed as "Perfectly
compensated" in the figure above.
1-10
Perfectly compensated
Figure 1-12 Probe Compensation
Chapter 1 Quick Start
Under compensated
MSO7000/DS7000 User Guide
Advertisement
Table of Contents
