To Select Measurement Mode; To Set The Limits - Rigol MSO7000 Series User Manual

Chapter 7 Digital Voltmeter (DVM) and Frequency Counter
Note: Even if the analog channel (CH1-CH4) is not enabled, you can still perform the
DVM measurement.

To Select Measurement Mode

Press Mode in the "DVM" setting menu, then rotate the multifunction knob
select the desired mode, and then press down the knob to select the mode. You can
also press Mode continuously to select the mode or enable the touch screen to tap
the desired mode and select it. The DVM measurement modes include AC RMS, DC,
and AC+DC RMS.
AC RMS: displays the root-mean-square value of the acquired data, with the DC
⚫
component removed.
DC: displays the average value of the acquired data.
⚫
AC+DC RMS: displays the root-mean-square value of the acquired data.
⚫

To Set the Limits

Press Limits to enter the sub-menu of Limits. Then set the following parameters.
Beeper
⚫
Press Beeper continuously to enable or disable the beeper.
Limits Condition Setting
⚫
Press When, then rotate the multifunction knob
setting condition. Press down the knob to select it. You can also press When
continuously or enable the touch screen to select it. The limits conditions include
"In Limits" and "Out Limits".
In Limits: when the voltage value is within the limits, you can enable or
➢
disable the beeper to sound an alarm.
Out Limits: when the voltage value is outside of the limits, you can enable
➢
or disable the beeper to sound an alarm.
Upper/Lower Limit Setting
⚫
Press Upper, then rotate the multifunction knob
keypad to set the upper limit of the voltage.
Press Lower, then rotate the multifunction knob
keypad to set the lower limit of the voltage.
MSO7000/DS7000 User Guide
to select the desired limit
or use the pop-up numeric
or use the pop-up numeric
RIGOL
to
7-3