To Install Video Support - HP OmniBook 800 Evaluator Manual

To install video support

Before installation of this display driver, the system display should be set to VGA
mode. VGA is the default video mode enabled when OS/2 is first installed. If the
current system primary display is not VGA, or if a previous version of this driver is
being used, the system should first be returned to VGA mode. To restore VGA mode,
use Selective Install and select VGA for Primary Display. For more information on
this procedure, see the section about "Changing Display Adapter Support" in the
OS/2 User's Guide.
Requirements
OmniBook 800 with OS/2 Warp 4.0.installed.
OmniBook 800 driver for video support.
Location: OmniBook hard drive or Recovery CD in
\OMNIBOOK\DRIVERS\OS2\VIDEO.
1. Open an OS/2 full screen or windowed session.
2. Place the HP OmniBook OS/2 Drivers disk in drive A.
3. Type A: <ENTER>.
4. Type SETUP C <ENTER> where C is the hard disk partition containing \OS2.
5. Select Primary Display from the Display Driver Install Window, then click OK.
6. From the list of Primary Display Adapter Types, NeoMagic - -
MAGICGRAPH128Z/ZV, then click OK.
7. Click OK to Install Using Defaults for Monitor Type in the Monitor
Configuration/Selection Utility window.
This will automatically test all video resolutions
8. Click OK to accept A:\ as the source directory.
9. If prompted to overwrite newer files, click Yes each time.
10. Remove the disk, then click OK when prompted.
11. After the installation program is finished, the display driver is initialized for
640x480x256 color.
12. Shut down and then reboot the system.
Using OS/2 Warp 4.0
Installing OS/2 Warp 4.0
6-7