Using Windows Nt 4.0; Installing Windows Nt 4.0; To Disable Infrared; To Install Windows Nt 4.0 - HP OmniBook 800 Evaluator Manual

Installing Windows NT 4.0

This section describes how to set up the operating system and drivers including:
Disabling the infrared port.
Installing Windows NT 4.0.
Installing video support.
Installing sound support.

To disable infrared

Windows NT 3.51 does not support infrared communications. Disable the infrared
port on the OmniBook before installing Windows NT.
1. Restart the OmniBook.
2. Press F2 when prompted to enter the System Configuration Utility (SCU).
3. Using the Alt key, open the Input/Output menu and deselect Enable IrDA IR.
4. Save and Exit the SCU.

To install Windows NT 4.0

This installation assumes an external CD-ROM and a previously completed standard
HP Windows 95 or Windows for Workgroups installation.
1. Press Ctrl+Alt+On/Off.
2. Connect the CD-ROM drive and insert the Windows NT 4.0 Installation CD.
3. Connect the OmniBook floppy disk drive.
4. Insert the Windows NT 4.0 Setup Boot Disk 1 into the floppy disk drive.
5. Press the blue On/Off button.
6. When prompted, insert Disk 2, then press Enter.
7. At the Welcome Screen, Press Enter to begin.

Using Windows NT 4.0

Installing Windows NT 4.0
5-3