Installing Cards; To Install The Xircom Ethernet Iips Pc Card - HP OmniBook 800 Evaluator Manual
Corporate evaluator’s guide
Hide thumbs
Also See for OmniBook 800:
- Installation and setup manual (88 pages) ,
- User manual (79 pages) ,
- Getting started manual (54 pages)
Table of Contents
Advertisement
Installing Cards
This section describes how to install the following:
Xircom Ethernet IIps PC card.
3Com 3C562 EtherLink III LAN+33.6 Modem PC card.
Intel EtherExpress PRO/100B PCI LAN adapter.
To install the Xircom Ethernet IIps PC card
Requirements
OmniBook 800 with Windows NT 3.51 installed.
Xircom Ethernet IIps PC card.
Windows NT 3.51 CD-ROM.
Xircom Drivers Disk v2.30.
Configuration
I/O Port: 0x300.
Memory Address: 0xD4000.
Interrupt: 11.
Mode: I/O Mode.
Cable Type: Auto Detect.
This procedure assumes that Windows NT Networking has not been installed.
1. Insert the PC card.
2. If you are accessing the Windows NT installation files from the CD-ROM make
sure the CD-ROM drive and the floppy disk drive are connected.
3. Connect ac power, then restart Windows NT 3.51.
4. From Control Panel, click Network.
5. Click Yes to begin the Windows NT Network Installation.
Using Windows NT 3.51
Installing Cards
4-9
Advertisement
Table of Contents
