To Install Video Support - HP OmniBook 800 Evaluator Manual

29. Enter your user name and password. If you are connecting to a network, get
30. Enter your password again to confirm, then click Continue.
31. Click Continue to accept MS-DOS Editor.
32. Enter the correct Time Zone and Date and Time, then click OK.
33. Click OK at the Detected Display window.
34. Click OK at the Display Settings window. (The video driver will be installed in
35. Click Yes to create an Emergency Repair Disk.
36. Insert a blank floppy disk, then click OK.
37. Remove the floppy disk, then click Restart Computer.

To install video support

Requirements
Important
1. From Control Panel, double-click Display, then click Change Display Type.
2. Under Adapter Type, click Change.
3. Click Other.
4. Enter the directory of the video drivers, then click OK.
5. Select the NeoMagic MagicGraph 128/V/ZV, then click Install.
6. Click Yes to confirm.
7. Click Continue to accept the video drivers directory.
This password is used to administer User IDs and Windows NT security.
these from your network administrator.
the next section.)
OmniBook 800 with Windows NT 3.51 installed.
OmniBook 800 drivers for video support.
Location: OmniBook hard drive or Recovery CD in
\OMNIBOOK\DRIVERS\NT\VIDEO\NT351.
The Windows NT 3.51 drivers must be installed from disk. If you have
formatted your hard disk drive and are using the Recovery CD, copy the
\OMNIBOOK directory from the Recovery CD to the hard disk drive.
Using Windows NT 3.51
Installing Windows NT 3.51
4-5