HP OmniBook 800 Evaluator Manual page 29

Requirements
OmniBook 800 with Windows 3.1 or Windows for Workgroups 3.11 installed.
OmniBook 800 Windows 3.x Driver Setup Program.
Location: Recovery CD in \OMNIBOOK\WFW_DRV. Copy this program to four
floppy disks or install it from the CD-ROM.
OmniBook Support Utility Disk is required if you install from CD-ROM.
1. Connect the CD-ROM drive and floppy disk drive.
2. Insert the Recovery CD.
3. Insert the OmniBook Support Utility Disk.
4. Turn on the OmniBook or exit Windows and press Ctrl+Alt+Del to reboot.
5. Choose MS-DOS Prompt With SCSIU CD-ROM Support. The Support Utility Disk
will load the internal and SCSI CD-ROM drivers. Ignore any errors.
6. Go to C:\WINDOWS and type WIN.
7. In Program Manager, choose File Run and enter
drive letter\OMNIBOOK\WFW_DRV\DISK1\SETUP on the Recovery CD.
8. Follow the instructions as they appear.
9. If these drivers are installed with Windows 3.1, infrared support will not be
available. There is no infrared support for Windows 3.1. See command-line
switches below.
10. When the installation is finished, remove the disk, click OK and restart
Windows.
Command-line Switches
If the setup program determines that you have Windows for Workgroups
installed on your OmniBook, it will install the infrared drivers. If the setup
program incorrectly identifies your system as a Windows 3.1 system, you can
force it to install the infrared drivers by invoking setup as follows:
SETUP ir+
If you have Windows for Workgroups but do not want the infrared drivers
installed, you can force the setup program to not install these drivers by
invoking setup as follows:
SETUP ir-
The setup program can be run in "terse" mode, which requires no interaction
from the user (unless an error occurs) by invoking setup as follows:
Using Windows 3.x
Installing Windows 3.x
2-5