To Install Video Support - HP OmniBook 800 Evaluator Manual

Important
28. Click Finish to finish setting up Windows NT.
29. Enter the correct Time Zone and Date and Time, then click Close.
30. Click OK twice to accept the VGA-Compatible Display Adapter. (The video
31. Insert a blank disk , then press Enter.
32. Remove the disk from the floppy disk drive and label it:
33. Press Enter to reboot.

To install video support

Requirements
1. From Control Panel, double-click Display, then click Settings.
2. Click Display Type, then click Change.
3. Click Have Disk in the Change Display window.
4. Enter the directory of the video drivers, then click OK.
5. Select the NeoMagic MagicGraph 128 V/Z, then click OK.
6. Click Yes to confirm.
7. Click OK to accept that the driver was installed correctly.
8. Click Close in the Display Type window. (The new driver will not take effect
9. Click Close in the Display Properties window.
We recommend that you install Windows NT networking after Windows NT is
fully installed. Follow the instructions in the application notes for the network
card you are using. The application notes are available from our website.
Sample application notes are included at the end of this chapter.
driver will be installed in the next section.)
"OmniBook Windows NT 4.0 Emergency Repair Disk"
OmniBook 800 with Windows NT 4.0 installed.
OmniBook 800 driver for video support.
Location: OmniBook hard drive or Recovery CD in
\OMNIBOOK\DRIVERS\NT\VIDEO\NT40.
until after Windows NT has restarted.)
Using Windows NT 4.0
Installing Windows NT 4.0
5-5