To Install An Intel Etherexpress Pro/100B Pci Lan Adapter - HP OmniBook 800 Evaluator Manual

Note
Using Windows NT 3.51
Installing Cards
12. Enter the settings listed above in the EtherLink III LAN+336 Modem PC card
V1.60 window, then click Continue.
13. Select the Protocols you wish to install, then click Continue.
14. If you installed the TCP/IP protocol you will be prompted for the TCP/IP
Installation options. Select the appropriate choices for your network.
15. Click OK at the Network Settings window.
16. If you installed the TCP/IP protocol and you chose not to use DHCP you will be
prompted to enter your TCP/IP information.
17. Click OK at the Network Setup Warning message window.
18. Click No to continue with the installation.
19. Enter the Workgroup name, then click OK.
If you need to connect to a domain, you will not be able to input the name at
this time. Restart the OmniBook. Under Network Setup, enter the domain
name.
20. When prompted, click Restart Computer.
If you need to enter a domain name, continue with the following 3 steps.
21. From Control Panel, double-click Network.
22. Type the correct Domain Name, then click OK.
23. When prompted, click Restart Computer.
To install an Intel EtherExpress PRO/100B PCI LAN
adapter
Requirements
OmniBook 800 with Windows NT 3.51 installed.
Intel EtherExpress PRO/100B PCI LAN Adapter.
Windows NT 3.51 CD-ROM.
Intel Drivers Disk.
This procedure assumes that Windows NT Networking has not been installed.
1. Insert the PCI card into the OmniBook Docking System.
4-12