To Install An Intel Etherexpress Pro/100B Pci Lan Adapter - HP OmniBook 800 Evaluator Manual

Using Windows 3.x
Installing Cards
To install an Intel EtherExpress PRO/100B PCI LAN
adapter
Requirements
OmniBook 800 with Windows for Workgroups 3.11 installed.
Intel EtherExpress (TM) PRO/100B PCI adapter (8465B).
Intel drivers:
E100B.DOS DOS NDIS 2.01 driver version 1.34 03/13/96.
E100B.386 Windows for Workgroups version 1.70 05/01/96.
1. Follow the instructions in the OmniBook Docking System User's Guide to install
the network card. Dock the OmniBook.
2. Reboot the OmniBook.
3. From Program Manager, double-click Network group, then Network Setup.
4. If the Drivers button is grayed, click the Networks button, then select Install
Microsoft Windows Network, then click OK.
5. Click Drivers, then Add Adapter.
6. Select Unlisted or Updated Network Adapter, then click OK.
7. When prompted, insert the Intel driver disk into drive A, then click OK.
8. Select the Intel 82557-based PCI LAN Adapter (NDIS2/NDIS3), then click OK.
Parameters such as IRQ and I/O address are not changeable.
9. When prompted, choose a Workgroup and enable sharing if applicable.
10. When prompted, insert Windows 3.11 disks 7 and 8.
After the files have been copied, you will see a series of Windows messages. If
you are using the default Windows for Workgroups configuration, the first
message will state that the Network Setup did not change the AUTOEXEC.BAT
or CONFIG.SYS file. This is due to our use of a multi-configuration. You can
either enter the NET START statement to the beginning of your AUTOEXEC.BAT
or run it from the DOS prompt. Remove the /N from the WIN /N statement at the
end of the AUTOEXEC.BAT to enable networking logon.
11. Reboot the OmniBook.
2-10