HP OmniBook 800 Evaluator Manual page 66

Note
Using Windows NT 3.51
Installing Cards
6. Enter the directory of the Windows NT 3.51 installation files (D:\i386 if installing
from CD-ROM).
7. Select Do Not Detect in the Network Adapter Card Detection window.
8. Click Continue.
9. Select Other Requires Disk From Manufacturer, then click Continue.
10. Insert the Xircom Drivers Disk, then click OK to accept A:\.
11. Click OK to accept Xircom CreditCard Ethernet IIps.
12. Enter the settings listed above in the Xircom CreditCard Ethernet IIps Setup
v1.33 window, then click Continue.
13. Select the Protocols to install, then click Continue.
14. If you installed the TCP/IP protocol, you will be prompted for the TCP/IP
installation options. Select the appropriate choices for your network.
15. Click OK at the Network Settings window.
16. If you installed the TCP/IP protocol, and you chose not to use DHCP, you will
be prompted to enter your TCP/IP information.
17. Click OK at the Network Setup Warning message window.
18. Click No to continue with the installation.
19. Enter the Workgroup name, then click OK.
If you need to connect to a domain, you will not be able to input the name at
this time. Restart the OmniBook. Under Network Setup, enter the domain
name.
20. When prompted, click Restart Computer.
If you need to enter a domain name, continue with the following 3 steps.
21. From Control Panel, double-click Network.
22. Type the correct Domain Name, then click OK.
23. When prompted, click Restart Computer.
4-10