To Install Os/2 Warp 4.0 - HP OmniBook 800 Evaluator Manual

To install OS/2 Warp 4.0

This procedure is not intended to replace your OS/2 Documentation. Please refer to
your OS/2 Documentation for complete instructions.
1. Connect the OmniBook external CD-ROM drive and insert the installation CD.
2. Connect the floppy drive and insert the installation disk into the floppy drive.
3. Restart the OmniBook.
4. When prompted, remove the Installation Disk from drive A, insert the OS/2 Disk
1, then press Enter.
5. When prompted, remove the OS/2 Disk 1 from drive A, insert the OS/2 Disk 2
and press Enter.
6. Press Enter when the Welcome screen is displayed.
7. When the Installing OS/2 screen is displayed, select Easy Installation or
Advanced Installation based on your needs.
8. If you choose Advanced Installation you will be asked if you wish to format the
hard disk drive. Make sure you have backed up the OmniBook 800 OS/2 Drivers
before formatting the hard disk drive. If Windows 95 is installed on this
OmniBook, we recommend that you format the hard disk drive. Windows 95
and OS/2 Warp are not compatible.
9. When prompted to reinsert disks 1 and 2, do so and press Enter.
10. After the OS/2 Warp base operating system is installed, you will be prompted to
remove the disk from drive A, then press Enter.
After the OmniBook 800 restarts, the System Configuration window is displayed.
11. Select Primary Display and then Video Graphics Array (VGA). Click OK. (You
will add Video Support later)
12. Click on Multimedia Device Support.
13. Remove any listed sound device, then click OK.
14. Click on Printer Support. The Select System Default Printer window is
displayed, use the arrow keys to highlight the name of your printer and the port
to which your printer is connected, then click OK.
15. Click Next.
16. Click Next at the System Configuration window.
Using OS/2 Warp 4.0
Installing OS/2 Warp 4.0
6-5