ZyXEL Communications XS1930-12F User Manual page 69

In the Static VLAN screen, select ACTIVE, enter a descriptive name in the Name field and enter 2 in the
2
VLAN Group ID field for the VLAN2 network. Use the default VLAN type, Normal, in the VLAN Type field.
Note: The VLAN Group ID field in this screen and the VID field in the IP Setup screen refer to the
same VLAN ID.
Since the VLAN2 network is connected to port 1 on the Switch, select Fixed to configure port 1 to be a
3
permanent member of the VLAN only.
To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly, clear
4
the TX Tagging check box to set the Switch to remove VLAN tags before sending.
Click Add to save the settings to the run-time memory. Settings in the run-time memory are lost when the
5
Switch's power is turned off.
Chapter 5 Initial Setup Example
XS1930 Series User's Guide
69