ZyXEL Communications XS1930-12F User Manual page 87

Figure 60 Basic Setting > General Setup
The following table describes the labels in this screen.
Table 25 Basic Setting > General Setup
LABEL DESCRIPTION
System Name Choose a descriptive name for identification purposes. This name consists of up to 64 printable
characters; spaces are allowed.
Location Enter the geographic location of your Switch. You can use up to 128 printable ASCII
characters; spaces are allowed.
Contact Person's Enter the name of the person in charge of this Switch. You can use up to 32 printable ASCII
Name characters; spaces are allowed.
Use Time Server Enter the time service protocol that your time server uses. Not all time servers support all
when Bootup protocols, so you may have to use trial and error to find a protocol that works. The main
differences between them are the time format.
When you select the Daytime (RFC 867) format, the Switch displays the day, month, year and
time with no time zone adjustment. When you use this format it is recommended that you use a
Daytime timeserver within your geographical time zone.
Time (RFC-868) format displays a 4-byte integer giving the total number of seconds since 1970/
1/1 at 0:0:0.
NTP (RFC-1305) is similar to Time (RFC-868).
None is the default value. Enter the time manually. Each time you turn on the Switch, the time
and date will be reset to 2020-01-01 0:0:0.
Time Server IP Enter the IP address or domain name of your timeserver. The Switch searches for the timeserver
Address for up to 60 seconds.
Time Server Sync Enter the period in minutes between each time server synchronization. The Switch checks the
Interval time server after every synchronization interval.
Current Time This field displays the time you open this menu (or refresh the menu).
New Time Enter the new time in hour, minute and second format. The new time then appears in the
(hh:min:ss) Current Time field after you click Apply.
Current Date This field displays the date you open this menu.
New Date (yyyy- Enter the new date in year, month and day format. The new date then appears in the Current
mm-dd) Date field after you click Apply.
Chapter 8 Basic Setting
XS1930 Series User's Guide
87