ABB PVS-100-TL-B-SY2 Product Manual page 172

• Slide the gasket protective covers between power module
box
• Remove the power module
procedure in the "Mounting with a support bracket - Assembly the
Inverter to the bracket" chapter in the reverse order and the indication
for lifting methods in "Type of lifting" chapter.
Never leave the power module
necessary to disassemble the power module
openings (long term installation) kit is available as accessory options.
To dismantling and disassemble the wiring box
• Remove the power module
• Remove AC cables and protective earth clable.
• Remove any signal cables.
• Remove the wiring box
procedure in the "Mounting with a support bracket - Assembly the
Inverter to the bracket" chapter in the reverse order and the indication
for lifting methods in "Type of lifting" chapter.
To dismantling and disassemble the mounting bracket
indications for the mounting procedure in the "Mounting with a support
bracket - Bracket assembly" chapter in the reverse order.
enclosures.
02
01
or the wiring box
01
only, a IP65 protection covers for wiring box
01
01
following the indications for the mounting
02
- 172 -
8 - Maintenance
following the indications for the mounting
disassembled on the field. In case is
02
follow these steps:
02
as previously described.
and wiring
01
follow the
03