ABB PVS-100-TL-B-SY2 Product Manual page 122

Inverter Parameters > Frequency Control: P(f) (Only
visible and editable with Admin Plus privileges)
In the Frequency Control: P(f) sub-menu you can config settings relat-
ed to the active power derating as function of grid frequency.
Do not change these parameters if not requested by the grid operator.
Inverter Parameters > Ramp Control (Only visible and
editable with Admin Plus privileges)
In the Ramp Control sub-menu you can config the parameter related
to the active power ramp up at the start-up and after a grid fault event.
Do not change these parameters if not requested by the grid operator.
Inverter Parameters > Reactive Power Control (Only
visible and editable with Admin Plus privileges)
In the Reactive Power Control sub-menu you can configure settings
related the reactive power parameters using the following parameters
groups:
1. Watt/Cosphi Settings: Cosphi(P)
2. Q Set
3. Cosphi Set
4. Volt/VAr Settings: Q(V)
Do not change these parameters if not requested by the grid operator.
- 122 -
7 - Operation