Chapter 6: Attaching Headers; Attaching Header Boots - MacDon M155E4 Unloading And Assembly Instructions

Chapter 6: Attaching Headers

6.1 Attaching Header Boots

Header boots are required to attach a D Series or D1 Series Draper Header to the windrower. Attach header boots
(supplied with header) to windrower lift linkage if not already installed.
IMPORTANT:
To prevent damage to the lift system when lowering header lift
linkages without a header or weight box attached to the
windrower, ensure the float engagement pin is installed in
storage position (B) and NOT in engaged position (A).
1. Remove pin (B) from boot (A).
2. Position boot (B) onto lift linkage (A) and reinstall pin (C).
Pin may be installed from either side of boot.
3. Secure pin (C) with hairpin (D).
4. Repeat for opposite side.
215104
Figure 6.1: Header Float Linkage
Figure 6.2: Header Boot
B
Figure 6.3: Header Boot
183
A
A
A
D
C
B
B
Revision A