Attaching Headers; Attaching A D-Series Header - MacDon M 2014 Series Original Instruction

6.22 Attaching Headers

6.22.1 Attaching a D-Series Header

The D-Series headers can be attached to an M105, M155, or M205 Self-propelled Windrower. For attachment
procedure, refer to the specific windrower model.
M105 Self-Propelled Windrower
To run a D-Series draper header, the M105 Self-propelled
Windrower needs to be equipped with reel drive, reel lift,
and reel fore-aft hydraulics.
Windrowers equipped with D-Series hydraulics have four
header drive hoses on the left-hand side, and up to five
reel drive hoses on the right-hand side.
If necessary, obtain the following kits from your MacDon
Dealer, and install them in accordance with instructions
supplied with the kits.
Kit Description
Base Draper Drive kit
Refer to the procedure that is appropriate for the center-link
installed on the windrower:
• Attaching a D-Series Header: Hydraulic Center-Link
without Self-Alignment, page 118
• Attaching a D-Series Header: Mechanical Center-Link,
page 124
169886
ASSEMBLING THE WINDROWER
Kit
Number
B5577
Figure 6.159: M105 Draper Header Reel
Hydraulics
111
Revision A