Adjusting The Sensor - Novexx Solutions 64 Series User Manual

01/13 Rev. 5.05-01
1. Select parameter
2. Press the ENTER button
3. Repeatedly press the CUT button
4. Press the ENTER button
5. Press the ENTER button
6. Move the bouncer arm appr.
7. Press the ENTER button
8. Move the bouncer arm up to the
9. Repeatedly press the CUT+FEED

USER MANUAL
Rewinder 2000

Adjusting the sensor

The bouncer arm controls the winding speed of the rewinder by means of a
sensor. Bevor applying the rewinder for the first time, the bouncer arm has
to be brought in both end positions to adjust the sensor.
Fig. 2 Left side: bouncer arm in zero position; right side: bouncer arm in final position.
Action
SYSP >
until
5 mm out of the zero position.
Press the ENTER button.
stop plate in the direction of the
support leg, and then back again
by approx. 5 mm. Press the
ENTER button.
button until
Set the value approx. 5 mm before reaching the final or zero position,
respectively!
Display Note
PEPH. PEPH
If the rewinder has already been
RWND
set.
RADJ
RNUL Initially setting of the sensor with
the bouncer arm in the zero
position. (See fig. above left)
xxx = actual sensor value; the
xxx
displayed value is altered by
moving the bouncer arm.
REND
xxx xxx = actual sensor value; the
displayed value is altered by
moving the bouncer arm.
RWND
OFF
9
Attachment, Setup