Jumper Settings; Connecting Motor / Sensor - Novexx Solutions 64 Series Service Manual

03/02 Rev. 2.14-02
64-xx – CHESS x – DPM – ALX 92x – Novexx PA-1x6

Jumper settings

Each of the applied three, four or five printer motors is controlled by a
separate output stage board. T he boards only differ from each other in the
jumper setting (Fig. 3:).

Set the jumper.
Motor
Options motor (e.g.
Cutter, Rewinder;
Dispenser Version:
Release motor)
Printhead motor
Ribbon motor
Feed motor
Dispenser motor
(ALX 924 / 64-xx
Dispenser)
Fig. 3: The Jumper position (1) on the board must match the motor.

Connecting motor / sensor

Both, motor and sensor cables are supplied with marked sleeves at their
ends. T he markings are abbreviations of the corresponding motor or sensor
designation, respectively.
Fig. 4: Cable marker (FM = feed motor).
Output stage
for...
Feed motor
Ribbon motor
Printhead motor
Options motor
Dispenser motor
Tab. 2: Markers at motor and sensor cables.
SERVICE MANUAL
Jumper
Pos.
1
Cable marker
motor sensor
FM –
RM RS
HM HS
OM OS
WM –
Service - Boards, Page 9